Consumer and FPV drones
₹1,000
DJI Mini, Air, Mavic, Avata, Neo, Flip, Lito, FPV and other small drones.
Drone fell in water
A drone that has been in a river, a pool, the sea or heavy rain can often be saved, but only if it is not powered on while wet. What you do in the first minutes matters more than anything we do later. Here is what to do now, what not to do, and how NVX checks a wet drone.
Service charge
₹1,000
DJI Mini, Air, Mavic, Avata, Neo, Flip, Lito, FPV and other small drones.
₹2,500
DJI Matrice, Mavic 3 Enterprise, DJI Agras and other agriculture drones, Saksham, BAAZ and other industrial drones.
Parts and repair work are quoted after the check, before any work starts.
Do these in order, as soon as you get the drone back.
If it is still on, power it off straight away.
Take the battery out and keep it apart from the drone.
Gently tip out water through the vents, without shaking the drone hard.
Tell us if it was sea water, pool water, a river or rain. It changes what we check.
Photograph the drone and the battery before you pack them.
Corrosion keeps working inside the drone after it looks dry.
These are the steps that turn a repairable drone into a dead one.
Switching on a wet drone can short the main board or the ESCs.
A battery that has been in water may be unsafe. Keep it away from anything flammable and message us first.
A hair dryer or a hot surface can warp parts and push water further in.
Leaving it to dry out on its own gives corrosion time to spread.
Every wet drone gets a full inspection before any quote.
We open the drone and look for water and corrosion on the main board, ESCs, connectors and sensors.
Affected boards and connectors are cleaned and dried before any power test.
Power, motors, gimbal and camera, GPS and compass, vision sensors and the radio link.
The battery is checked separately and replaced if it is not safe.
Water damage has no fixed price. The cost depends on how long the drone was wet, the type of water, whether it was powered on afterwards, and which parts are damaged: a cleaned connector costs far less than a new main board or gimbal camera. You get a quote after the inspection, and nothing is replaced until you approve it.
The same tracked process for every repair, whether you visit or courier the drone.
Model, what happened and a few photos. It takes about three minutes.
Bring it to Connaught Place or send it by courier. Contact us first about damaged batteries.
A technician finds the fault and quotes before any work starts.
Approved work is done, sensors are calibrated, and the drone is test-flown where safe.
Pick it up or get it couriered back, with a summary of the work done.
FAQ
Often, yes, if it was switched off quickly and has not been powered on since. Remove the battery, do not charge it, and bring or courier the drone to us as soon as you can.
Do not rely on it. Drying the outside does not remove water or corrosion from the boards inside. An inspection that opens the drone is the safer option.
Usually, yes. Salt left behind after drying keeps corroding the electronics, so tell us if the drone was in the sea and send it in quickly.
Yes, in many cases. NVX is a DJI service centre. For in-warranty or DJI Care Refresh cases, contact us first and we will confirm the right route.
It depends on what the water damaged. NVX inspects the drone first and quotes before any work. The service charge is ₹1,000 for consumer and FPV drones and ₹2,500 for enterprise and agriculture drones.
Courier the drone. For the battery, message us first: a battery that has been in water may not be safe to ship.
Book a repair
Visit us at C Block, C42/2, 1st Floor, Dwarka Sadan, Middle Circle, Connaught Place, New Delhi, Delhi 110001 (Mon-Sat, 11:00 AM-7:00 PM), or courier your drone from anywhere in India.
Related