Flying manual

Use the reviewed beginner setup before first operation.

1. 1Set gyro mode to ON.
2. 2Keep the motor horizontal.
3. 3Check that both wings are symmetrical.
4. 4Use a gentle level throw.

Complete a short pre-flight check before every launch.

1. 1Place Titli flat.
2. 2Power on the unit.
3. 3Wait for gyro calibration and light stabilisation.
4. 4Launch level in a safe, open area.

Motor angle affects lift and forward motion.

1. 1Motor down may create more lift and can stall if overdone.
2. 2Motor horizontal is the balanced beginner setup.
3. 3Motor up may increase forward speed and can cause diving or crashing.

Left turning may come from wing imbalance, gyro drift, or uneven motor setup.

1. 1Press the BOOT button.
2. 2Hold slight right correction for 5-15 seconds.
3. 3Lower the left side slightly or raise the right side slightly.
4. 4Check wing symmetry and damage.

Right turning may come from wing imbalance, gyro drift, or uneven motor setup.

1. 1Recalibrate using BOOT.
2. 2Hold slight left correction for 5-15 seconds.
3. 3Raise the left side slightly or lower the right side slightly.
4. 4Relaunch level.

Use conservative public safety wording until technical thresholds are approved.

1. 1Charge the battery before use.
2. 2Use only compatible charging input and accessories confirmed by NVX.
3. 3Monitor battery usage during operation.
4. 4Reduce throttle before landing or after a collision.
5. 5Allow cooling after extended use in hot conditions.
6. 6Do not operate in rain or high-humidity conditions.
7. 7Do not attempt unsupported controller re-pairing or reconfiguration.
8. 8Operate indoors or outdoors only in calm-wind conditions.